All Resources

Innovative Energy Technologies Program project 06-094 : cyclic solvent test pilot

Description

Reports on a cyclic solvent process (CSP) experimental pilot project at Cold Lake in the Clearwater formation. CSP is a non-thermal, in-situ bitumen recovery process that utilizes injected solvent... More ≫

Description

Reports on a cyclic solvent process (CSP) experimental pilot project at Cold Lake in the Clearwater formation. CSP is a non-thermal, in-situ bitumen recovery process that utilizes injected solvent to reduce the viscosity of the bitumen, enabling its production from wells drilled for that purpose. The liquid-phase solvent is injected into a horizontal well cyclically and, because of the large mobility contrast between the solvent and the bitumen, it fingers into the bitumen. Following injection, the solvent-bitumen blend is produced from the same well. Cyclic injection and production operations continue for multiple cycles over several years until the bitumen produced no longer justifies the cost of the solvent or until the bitumen production rate is no longer economic.

Tags

Innovative Energy Technologies Program project 06-095 : low-pressure electro-thermally assisted drive

Description

This pilot project was conducted in the Panny area within the Peace River Oil Sands Area. The intent of the project was to evaluate the potential of a low-pressure process that utilizes downhole... More ≫

Description

This pilot project was conducted in the Panny area within the Peace River Oil Sands Area. The intent of the project was to evaluate the potential of a low-pressure process that utilizes downhole electric heaters combined with water and/or solvent injection to recover bitumen from the Bluesky formation. This technology has the potential to be commercialized in both the Panny area as well as many other bitumen/heavy oil reservoirs in Alberta.

Tags

Innovative Energy Technologies Program project 06-101 : Suffield main sand alkali surfactant associative polymer flood

Description

The concept for this project is to inject EOR (Enhanced Oil Recovery) chemical into a conventional heavy oil reservoir with an active aquifer, to determine if this technology can yield economic... More ≫

Description

The concept for this project is to inject EOR (Enhanced Oil Recovery) chemical into a conventional heavy oil reservoir with an active aquifer, to determine if this technology can yield economic results. The project is a participant in the Innovative Energy Technology Program.

Tags

Innovative Energy Technologies Program project 05-075 : air injection and displacement for recovery with oil horizontal

Description

The purpose of Cenovus’ AIDROH (Air Injection and Displacement for Recovery from Oil Horizontal) project is to explore the viability of using horizontal wells to recover bitumen in the Kirby... More ≫

Description

The purpose of Cenovus’ AIDROH (Air Injection and Displacement for Recovery from Oil Horizontal) project is to explore the viability of using horizontal wells to recover bitumen in the Kirby Wabiskaw K-3 Pool that has been passively heated by combustion in the overlying gas zone. The project is a participant in the Innovative Energy Technology Program.

Tags

Innovative Energy Technologies Program project 03-047 : Cold Lake solvent assisted SAGD pilot

Description

Reports on a solvent-assisted steam assisted gravity drainage (SA -SAGD) experimental pilot scheme at Cold Lake in the Clearwater formation conducted by Imperial Oil. The experimental process... More ≫

Description

Reports on a solvent-assisted steam assisted gravity drainage (SA -SAGD) experimental pilot scheme at Cold Lake in the Clearwater formation conducted by Imperial Oil. The experimental process design for the pilot involves the addition of five to 20 per cent by volume of hydrocarbon solvent (diluent) along with the injected dry steam in a dual horizontal well SAGD configuration, which is intended to result in increased bitumen rates and decreased steam oil ratios relative to the conventional SAGD process.

Tags

Innovative Energy Technologies Program project 05-085 : Bodo east associative polymer pilot flood

Description

Reports on an associated polymer flood pilot conducted at the East Bodo Upper Mannville “A” pool sandstone heavy oil reservoir. The pilot pattern consisted of three vertical injectors and six... More ≫

Description

Reports on an associated polymer flood pilot conducted at the East Bodo Upper Mannville “A” pool sandstone heavy oil reservoir. The pilot pattern consisted of three vertical injectors and six vertical producers.

Tags

Innovative Energy Technologies Program project 05-077 : Saleski SAGD

Description

Reports on a pilot project in the Athabasca Grosmont Formation to evaluate the commercial potential of thermal recovery within a karsted carbonate reservoir. While steam assisted gravity drainage... More ≫

Description

Reports on a pilot project in the Athabasca Grosmont Formation to evaluate the commercial potential of thermal recovery within a karsted carbonate reservoir. While steam assisted gravity drainage (SAGD) has been demonstrated as a successful exploitation strategy within the McMurray clastics, the application of SAGD within a carbonate environment presents different challenges. A review of previous vertical well Cyclic Steam Stimulation (CSS) performance indicated that horizontal SAGD wells may prove to be an effective recovery process within the Grosmont Formation. Additionally, carbonate core analyses and lab testing further validated SAGD as an effective recovery process within the Grosmont Formation.

Tags

Innovative Energy Technologies Program project 05-088 : horizontal multi-state fracturing lowperm sandstones

Description

Reports on a project funded by the Innovative Energy Technologies Program to evaluate waterflood performance in low-permeability sandstones with multi-stage fractured horizontal wells. The project... More ≫

Description

Reports on a project funded by the Innovative Energy Technologies Program to evaluate waterflood performance in low-permeability sandstones with multi-stage fractured horizontal wells. The project involved drilling and completion of four multi-stage fractured horizontal wells in Pembina Cardium Unit 9 in low permeability and low waterflood recovery areas.

Tags

Innovative Energy Technologies Program project 06-098 : water management through water treatment technologies

Description

This project addressed water management challenges in the oil sands open pit mining process through the application of innovative water treatment technologies. New technologies such as ceramic... More ≫

Description

This project addressed water management challenges in the oil sands open pit mining process through the application of innovative water treatment technologies. New technologies such as ceramic ultra-filtration, nano-flotation system along with commercial desalinations techniques were demonstrated to provide real operating data for basal and tailings water treatments. This report discusses details of recently completed pilots with new technology flow sheets which were designed for a full-scale commercial oil sands mine water treatment plant. The project is a participant in the Innovative Energy Technology Program.

Tags

Innovative Energy Technologies Program project 03-050 : Redwater immiscible CO2 vertical pilot

Description

The Redwater immiscible CO2 vertical pilot project includes three existing production wells and a new production, injection and observation well. The project also includes dedicated injection and... More ≫

Description

The Redwater immiscible CO2 vertical pilot project includes three existing production wells and a new production, injection and observation well. The project also includes dedicated injection and production facilities ARC commenced CO2 injection on July 29th, 2008. The project is a participant in the Innovative Energy Technology Program.

Tags