All Resources

Technical guidance for completing specified gas compliance reports. Version 7.0

Description

The purpose of this document is to assist facilities regulated under the Specified Gas Emitters Regulation in completing annual compliance reports and to provide information about the compliance... More ≫

Description

The purpose of this document is to assist facilities regulated under the Specified Gas Emitters Regulation in completing annual compliance reports and to provide information about the compliance options available to facilities that are unable to meet their emissions reduction targets through facility level improvements. This document should be applied when completing compliance reporting for the 2013 emissions year.

Tags

Quantification protocol for distributed renewable energy generation. Version 1.0

Description

This protocol specifically addresses grid connected wind and solar generation projects with a rated electrical capacity of less than 1 MW located at the consumer end of the electric distribution... More ≫

Description

This protocol specifically addresses grid connected wind and solar generation projects with a rated electrical capacity of less than 1 MW located at the consumer end of the electric distribution system. Individual projects will yield small volume emissions reductions that cannot be processed as stand-alone offset projects in the Alberta Offset System. The methodology provided in this protocol is for aggregated, distributed renewable electricity projects. Familiarity with and general understanding of distributed energy system operations is required.

Tags

Quantification protocol for fuel switching in mobile equipment. Version 1.0

Description

This quantification protocol describes the process for quantifying greenhouse gas emission reductions resulting from converting mobile fleets to lower-greenhouse gas intensity fuels while... More ≫

Description

This quantification protocol describes the process for quantifying greenhouse gas emission reductions resulting from converting mobile fleets to lower-greenhouse gas intensity fuels while maintaining an equal or greater level of service.

Tags

Technical guidance for offset project developers. Version 4.0

Description

The purpose of this doucment is to assist offset market participants (protocol developers) wishing to develop quantification protocols for use in the Alberta offset system where the intended final... More ≫

Description

The purpose of this doucment is to assist offset market participants (protocol developers) wishing to develop quantification protocols for use in the Alberta offset system where the intended final purchaser of offset credits generated is a facility regulated under the Specified Gas Emitters Regulation. Alberta's offset market was initiated as a market instrument to support compliance under the Specified Gas Emitters Regulation. The Regulation requires all large, industrial facilities in Alberta emitting over 100,000 tonnes of carbon dioxide equivalent per year to reduce their emissions intensity by 12 per cent per year from their government approved baseline emission intensity.

Tags

Alberta greenhouse gas reporting program . . . facility emissions [2012-2013]

Description

Alberta’s Specified Gas Reporting Programhas collected facility greenhouse gas emissions data since 2003. In 2005 (for 2004 emissions data collection), Alberta harmonized its Specified Gas... More ≫

Description

Alberta’s Specified Gas Reporting Programhas collected facility greenhouse gas emissions data since 2003. In 2005 (for 2004 emissions data collection), Alberta harmonized its Specified Gas Reporting Programwith the Government of Canada’s Greenhouse Gas Emissions Reporting Program. Since then, Alberta has jointly collected greenhouse gas data from Alberta’s largest industrial emitters with the Government of Canada. Alberta facilities report their emissions data to Environment and Climate Change Canada through the federal reporting program and the results are forwarded to the Alberta Climate Change Office, allowing both provincial and federal reporting requirements to be satisfied.

Tags

Technical guidance for completing specified gas baseline emission intensity applications. Version 4.0

Description

The purpose of this document is to assist regulated facilities under the Specified Gas Emitters Regulation with the completion of Baseline Emissions Intensity Applications. A facility's stated... More ≫

Description

The purpose of this document is to assist regulated facilities under the Specified Gas Emitters Regulation with the completion of Baseline Emissions Intensity Applications. A facility's stated baseline emissions intensity (BEI) value must be representative of the facility's normal operating conditions. If the baseline period is not representative of that facility's standard operating conditions, the Certifying Official must contact Alberta Environment and Sustainable Resource Development to discuss an adjusted baseline period. More information on alternate baseline periods is available in section 3.2 of this guidance document.

Tags

Quantification protocol for direct reductions in greenhouse gas emissions arising from changes in forest harvesting practices. Version 1.0

Description

This quantification protocol describes the process for quantifying annual greenhouse gas emission reductions/removals arising from a change in forest harvesting practice from full tree harvesting... More ≫

Description

This quantification protocol describes the process for quantifying annual greenhouse gas emission reductions/removals arising from a change in forest harvesting practice from full tree harvesting with tree length hauling and chipping in a wood room at the mill to chipping using portable chippers.

Tags

Quantification protocol for reducing the age at harvest of beef cattle. Version 2.0

Description

This protocol quantifies decreases in greenhouse gas emissions associated with the raising of beef cattle by reducing the number of days required to get a feeder calf from birth to harvest. This... More ≫

Description

This protocol quantifies decreases in greenhouse gas emissions associated with the raising of beef cattle by reducing the number of days required to get a feeder calf from birth to harvest. This applies to youthful cattle, or those cattle under 24 months of age. In this context, feeder cattle that spend less time in backgrounding lots, on pasture and in the feedlot result in decreased greenhouse gas emissions. Withdrawn as of March 31, 2020.

Tags

Technical guidance for completing specified gas compliance reports. Version 4.0

Description

The purpose of this document is to assist facilities regulated under the Specified Gas Emitters Regulation in completing annual compliance reports. It also provides information on the compliance... More ≫

Description

The purpose of this document is to assist facilities regulated under the Specified Gas Emitters Regulation in completing annual compliance reports. It also provides information on the compliance options available for facilities that are not able to meet their emissions reduction target through facility level improvements.

Tags

Technical guidance for offset protocol developers. Version 1.0

Description

The purpose of this document is to assist offset market participants (protocol developers) wishing to develop quantification protocols for use in the Alberta offset system where the intended final... More ≫

Description

The purpose of this document is to assist offset market participants (protocol developers) wishing to develop quantification protocols for use in the Alberta offset system where the intended final purchaser of offset credits generated is a facility regulated under the Specified Gas Emitters Regulation. Alberta's offset market was initiated as a market instrument to support compliance under the Specified Gas Emitters Regulation. The Regulation requires all large, industrial facilities in Alberta emitting over 100,000 tonnes of carbon dioxide equivalent per year to reduce their emissions intensity by 12 per cent per year from their government approved baseline emission intensity.

Tags